• UT for Elbow pipes
• UT for gas cutting surface
• UT for weld bead
• UT for fillet weld in tee joint
• UT for weld bead
• UT for CFRP
• Cast iron: gap & narrow spot
• Cast iron: rough surface
• Cast iron: rough surface
• Cast iron: from cross section
• Inspection at the vertical portion
• Application of angle beam probe
• Application of straight beam & wheel probe
• Application of special probes
• Simulation inside pipe
• Simulation on fillet weld
• Simulation on welded bead
• Endurance test of flexible array probe

• Air plane wing & body (CFRP)
• Corner of Air plane wing (CFRP)

• Body CFRP
• Brake pad
• Lithium ion battery
• Ultrasonic inspection of a crankshaft #1
• Ultrasonic inspection of a crankshaft #2
• Cast iron: inspection of rough surface
• Cast iron: inspection from cross section

• UT for weld bead
• UT for fillet weld in lap joint
• UＴ for gas cutting surface
• UT for weld bead

• Lithium ion battery (in-situ)
• Lithium ion battery detect & Diagnosis
• Lithium ion battery
• Solar panel battery (internal, electrode)
• Wind mill generator blade (GFRP)

• Lithium ion battery

We introduce the inspection of weld bead by the Broadband Flexible Array Probe/ transducer "KYOKUTAN".

For conventional weld bead inspection, it is very difficult because the probe surface does not fit the uneven surface.
"KYOKUTAN" is flexible, so it fits to uneven surface and it makes the inspection of welded beam part easy.

You can watch the movie about ultrasonic inspection of simulated side drill hole Φ1mm in welded beam by the BFAP.