- UT for Elbow pipes
- UT for gas cutting surface
- UT for weld bead
- UT for fillet weld in tee joint
- UT for weld bead
- UT for CFRP
- Cast iron: gap & narrow spot
- Cast iron: rough surface
- Cast iron: rough surface
- Cast iron: from cross section
- Inspection at the vertical portion
- Application of angle beam probe
- Application of straight beam & wheel probe
- Application of special probes
- Simulation inside pipe
- Simulation on fillet weld
- Simulation on welded bead
- Endurance test of flexible array probe
- Body CFRP
- Brake pad
- Lithium ion battery
- Ultrasonic inspection of a crankshaft #1
- Ultrasonic inspection of a crankshaft #2
- Cast iron: inspection of rough surface
- Cast iron: inspection from cross section
Inspection at the vertical portion
We introduce the ultrasonic inspection & measuring to vertical condition and ceiling of upside-down condition by magnet probe.
In the inspection & measuring that touching vertical and ceiling part with ultrasonic probe, you have to hold the probe and it is difficult to set or calibrate ultrasonic testing equipment in such condition.
Probe with magnet is available for fitting to inspection material by the magnet force and also scanning is possible for inspection. Therefore the magnet probe is suitable inspection for vertical and ceiling place. you can inspect or detect these parts in stable condition.
You can easily inspect to vertical and ceiling parts：upside-down condition in handling ultrasonic detector.
