- UT for Elbow pipes
- UT for gas cutting surface
- UT for weld bead
- UT for fillet weld in tee joint
- UT for weld bead
- UT for CFRP
- Cast iron: gap & narrow spot
- Cast iron: rough surface
- Cast iron: rough surface
- Cast iron: from cross section
- Inspection at the vertical portion
- Application of angle beam probe
- Application of straight beam & wheel probe
- Application of special probes
- Simulation inside pipe
- Simulation on fillet weld
- Simulation on welded bead
- Endurance test of flexible array probe
- Body CFRP
- Brake pad
- Lithium ion battery
- Ultrasonic inspection of a crankshaft #1
- Ultrasonic inspection of a crankshaft #2
- Cast iron: inspection of rough surface
- Cast iron: inspection from cross section
UT for weld bead
We introduce the ultrasonic inspection method by using soft probe to weld bead: the detecting surface of our soft probe is very soft to enough fitting.
For conventional weld bead inspection, it is very difficult because the probe surface does not fit the uneven surface.
Japan Probe's soft probe realizes easy inspection and measurement to use soft probe.
You can watch the movie about ultrasonic inspection of simulated side drill hole Φ1mm in welded beam by soft probe.
